WZATCO projectors are built to last long, however while using our products users should pay attention to the following simple usage points to ensure longevity of the product.
- Operating Temperature – Wzatco projectors are meant to be used indoor in cool places where the temperature does not exceed 40 degrees. In case the room temperature is high, ensure that there is enough ventilation for the projector fans to be operate effectively. In such scenarios, its recommended to give a gap of 10 to 15 mins after every hour of usage.
- Operating Hours – Wzatco Projectors like other LCD projectors should be used for 3 to 4 hours at continuous stretch only and thereafter should be given a pause of 10 to 15 minutes. The projector should be turned off after 3 to 4 hours of continuous usage. This prevents any LCD burn out issues due to over heating.
- Dusty Conditions – Care should be taken not to operate the projector is a dust conditions. Too much dust leads to clogging of the exhaust vents which leads to heating issues. Ensure the filters are cleaned properly on regular basis. If outside dust is more, the filter cleaning needs to be done more often. Do not let the dust block the air filter which leads to poor ventilation.
- Surge Protection – Wzatco projectors are built to withstand ± 10% voltage fluctuation. In certain areas where the power outage is more, it is recommended to use a surge protection. Warranty does not cover any damage to the powerboard or adaptor due to power surge.
Kind Note: Wzatco offers 1 year carry in service warranty on it’s projectors. Customer is requested to visit WZATCO service center with defective product or courier the same. Wzatco will not bear courier charges paid by the customer. On request, we can provide assistance in arranging reverse pick up of the defective item from customer’s address and/or delivery of the repaired item upon repair. In both cases the shipping cost is customers responsibility.
